Currently Shopping by:
- Remove This Item Category: Planning/Construction
- Remove This Item Language: EN
Publications
ATV-A 200 - Wastewater Rurally Areas (5/1997)
This Standard indicates possibilities for the economic realisation of an ordered disposal of wastewater in rurally structured regions. However, with all the currently discussed measures for cost reduction, the actual aims, protection of lakes and rivers and safety of local hygiene may not be placed in jeopardy. Wastewater treatment plants in rurally structured areas should not be planned, built an... Learn More
ATV-DVWK-A 198 - Standardisation (4/2003)
This Standard is concerned with the definition, collection, evaluation and examination of data as well as with the subsequent derivation of dimensioning values based on these for wastewater treatment plants and drainage systems. Forecast data for various time horizons can subsequently be derived from measured data. With this Standard the objective is pursued, globally for all DWA Standards and Adv... Learn More
DWA-M 180E - Real Time Control (12/2005)
The Advisory Leaflet introduces the basic aspects of real time control to potential users and presents a sound level of knowledge to those planners, operators and administrations involved in the development of real time control systems. It aims to achieve the use of real time control as a potential alternative on a regular basis in future planning of drainage schemes. This includes simple local co... Learn More
DWA-A 161E - Static calculation (3/2014)
The standard was published in May 2018, based on the German edition of March 2014 in the corrected version of October 2017. This standard applies to the structural calculation of pipes with a circular cross-section which are installed according to the pipe jacking method in a straight or bending direction in non-cohesive or cohesive soils (loose soils as according to DIN 18319) with static force ... Learn More
DWA-A 138E - Facilities for Percipitation (4/2005)
The Standard ATV-A-138 dated January 1990 has been revised and increased it considerably in the area of application. In addition the symbols used have been matched to those in Standard ATV-DVWK-A 198 published in April 2003. The recording of all surfaces providing runoff in one standard with notes on special regulations enables a comparable taking into account of the demands of soil and water poll... Learn More
DWA-A 125E - Pipe Jacking (12/2008)
This Standard deals with the underground installation of pre-fabricated pipes with different geometry of the cross-section. During the installation, a cavity is created in the ground by displacing, ramming, drilling, pressing or other installation. The pipes are pulled, pushed or pressed into this cavity or existing sewers or pipelines are passed and/or replaced. For shield drives (e. g. segment l... Learn More
DWA-A 118E - Hydraulic Dimensioning (3/2012)
This DWA Standard concerns the dimensioning and verification of drain and sewer systems, which are mainly operated as gravity systems and which serve for the discharge of domestic and industrial wastewater, surface water and combined wastewater. It contains guidance for determining the quantities of wastewater to be discharged, taking into account both the replanning and the recalculation of exist... Learn More
DWA-A 100E - Urban Drainage (12/2006)
As a framework of action concerning the detailed regulations for urban drainage, this Standard is intended to Learn More
DWA-A 199-1 - Operating Instructions (11/2011)
Operators of wastewater facilities shall establish service and operating instructions tailored to their respective circumstances in order to adhere to the requirements especially of § 57 of the German Water Resources Management Law (WHG) and in order to meet the minimum requirements of the self-inspection or self-monitoring ordinances of Germany's federal states. Since the regulatory content of t... Learn More